011426 RFID/Keypad Secure Access Control Endpoint

The SIP-based RFID/Keypad Secure Access Control Endpoint uses the existing VoIP or PoE network infrastructure to securely unlock and lock gates or doors.

PoE powered and in a secure outdoor-rated case, the RFID/Keypad Secure Access Control Endpoint can store up to 500 access codes. There is a blacklisted code list that when activated, will make a phone call and play a pre-recorded message or can broadcast a multicast message to IP speakers when registered to the VoIP server. Good code and blacklisted code lists can be updated on the web interface or autoprovisioned by a remote server.

Security
CyberData has implemented a high level of security on its RFID products. Data between the card and the reader are encrypted using AES128 making sure that hackers would not be able to “spy” on the cards data being sent to the reader and duplicate that card to provide access.

Card Authentication
When a card is read, there is an additional security step. The reader and the card go through a complex mathematic process where they compare encrypted security keys. This process is called Mutual Authentication. It guarantees that communication between the card and the reader can never be copied and used to produce a duplicate card. On a good read, the keys will match and the reader will extract the encrypted data from the card to validate if the card is active in the system. If the keys do not match, the card will be rejected.

CyberData has maintained one of the most comprehensive list of IP PBX servers certified to work with CyberData VoIP products.

Device ships with 5 RFID cards and instructions.

• Mifare Plus X 2K/4K cards are supported for a high level of encryption
• 12 key keypad
• Alert buzzer
• Red/Green lock status lights
• Can operate in standalone mode. PBX not required. Future-proof and adaptable when upgrading to new VoIP PBX
• Built in time of access scheduler
• Local and remote logging with time stamp
• NTP time support
• Network web management
• Blacklisted code alert via dialout and multicast stored message
• Network downloadable firmware
• Dry contact relay to trigger door lock or unlock gates
• Door closure and tamper alert signal
• Security Torx screws with driver kit included

*Dimensions are measured from the perspective of the product being upright with the front of the product facing you.

How do I update my firmware?

Is this device compatible with my service provider or IP-PBX server?

Is a service provider or PBX required to use this product?

What kind of RFID cards can I buy if I need more?

Does this device offer two factor authentication?

Do I need additional software to program the RFID cards?

How can I prevent water or weather damage to the device if it is in a vulnerable location?

For additional support or answers to questions not covered on this page, who should I contact?

Typical Installation

Connecting to non-inductive type loads (Devices Less than 1A at 30 VDC)

This relay can be used to trigger low current devices like strobes and security camera input signals as long as the load is not an inductive type and the relay is limited to a maximum of 1 Amp @ 30 VDC.

Connecting to inductive type loads (Door Strike Intermediate Relay Module)
We highly recommend that inductive load and high current devices use our Door Strike Intermediate Relay Module product (CD# 011269).

Connecting to inductive type loads (Networked Dual Door Strike Relay)
We highly recommend that inductive load and high current devices use our Networked Dual Door Strike Relay product (CD# 011375).